Suzuki RA410, Manual

Page: 660 / 761

3) Remove back door trim.
4) Remove wire harness connectors inside the back door.
5) Remove back door balancers (1) (first at its door-side and next
at its body side, as shown).
WARNING:
Handling of Back Door Balancer (Damper)
Do not disassemble balancer (1) because its cylin-
der is filled with gas.
The gas itself is harmless but it may issue out of the
hole together with chips generated by the drill (2).
Therefore, be sure to wear gloggle.
When discarding removed back door balancer
(damper) use a 2 to 3 mm (0.08 to 0.12 in.) drill (2) to
make a hole as shown.
Handle balancer carefully. Do not scar or scratch
exposed surface of its piston rod, and never allow
any paint or oil to stick to its surface.
Do not turn piston rod with balancer fully extended.
1
1
2
1
6) Remove door hinge bolts and door.
10 mm (0.4 in.)
INSTALLATION
Reverse removal procedure to install back door noting the follow-
ing points.
Secure wiring harness (1).
Adjust door latch striker position by referring “BACK DOOR
LOCK ASSEMBLY INSTALLATION” so that door is positioned
correctly.
Adjust door cushion so that door contacts body when closed.
1
9-18 BODY SERVICE