4) Apply engine oil to cylinder head bolts and tighten them gradu-
ally as follows.
(1) Tighten all bolts to 30 N
.
m (3.0 kg-m, 21.5 lb-ft) according to
numerical order in figure.
(2) In the same manner as in (1), tighten them to 48 N
.
m (4.8
kg-m, 34.5 lb-ft).
(3) Loosen all bolts to 0 N·m (0 kg-m, 0 lb-ft) reversing to numeri-
cal order in figure.
(4) In the same manner as in (1) again, tighten them to 48 N·m
(4.8 kg-m, 34.5 lb-ft).
(5) In the same manner as in (1), tighten them to specified
torque.
Tightening Torque
60 N
.
m (6.0 kg-m, 43.5 lb-ft)
“1”:
Camshaft pulley side
“2”:
Distributor side
5) Install camshafts, camshaft housings, distributor, timing chain,
tensioner, tensioner link, tensioner adjuster, sprockets, and
guide as previously outlined.
6) Install timing chain cover.
Refer to item “TIMING CHAIN COVER” in this section for instal-
lation.
7) Install cylinder head cover.
Refer to item “CYLINDER HEAD COVER” in this section for
installation.
8) Install oil pan.
Refer to item “OIL PAN AND OIL PUMP STRAINER” in this sec-
tion for installation.
9) Install exhaust manifold (If it’s removed).
Refer to item “EXHAUST MANIFOLD” in this section for instal-
lation.
ENGINE MECHANICAL
6A4-53
Summary of Contents for RA410
