Suzuki RA410, Manual

Page: 557 / 761

2
1
“A” “B”
7B-30 AUTOMATIC TRANSMISSION
D
Adjust select cable as follows:
1) Before tightening cable end nut, shift select lever to N range.
2) Also shift manual select lever (1) to N range.
3) Turn nut “A” by hand till it contacts manual select cable joint.
4) Then tighten nut “B” with wrench to specified torque.
After select cable was installed, check for the following.
D
Push vehicle with select lever shift to P range.
Vehicle should not move.
D
Turn ignition switch “START” with select lever shifted to P and
N range.
Starting motor should not operate.
D
Turn ignition switch “ON” with select lever shifted to R range.
Back up light should light.
TRANSMISSION RANGE SWITCH
REMOVAL
1) Disconnect transmission range switch connector
2) Remove transmission range switch from transmission.
INSPECTION
Check for continuity at position indicated in the following table by
shifting select lever.
6 9 1 4 5 3 8 2 7
P
R
N
D
2
L
If any faulty condition is found in above check, replace transmis-
sion range switch.