Suzuki RA410, Manual

Page: 337 / 761

4) Install crankshaft to cylinder block.
5) Install lower crankcase to cylinder block.
Tighten crankcase bolts according to next procedure.
(1) Tighten bolts to to 41 N·m (4.1 kg-m, 29.5 lb-ft) in order
of their numbers.
(2) Tighten bolts to to 17 N·m (1.7 kg-m, 12.0 lb-ft) in order
of their numbers.
(3) In the same manner as in (1), tighten them to specified
torque.
(4) In the same manner as in (2), tighten them to specified
torque.
Tightening Torque
to
: 58 N·m (5.8 kg-m, 42.0 lb-ft)
to : 24 N·m (2.4 kg-m, 17.5 lb-ft)
NOTE:
After tightening lower crankcase bolts, check to be sure
that crankshaft rotates smoothly when turned by hand.
10 1
10 1
20 11
11 20
6) Install rear oil seal (3). With special tools, press fit rear oil seal
so that it is flash with cylinder block.
Special Tool
(A): 09911-97020
(B): 09911-97030
1. Crankshaft side
2. Oil seal side
1
2
3
7) Install flywheel (M / T model) or drive plate (A / T model).
Using special tool, lock flywheel or drive plate, and torque its
bolts to specification.
Special Tool
(A): 09924-17810
Tightening Torque
(a): 70 N
.
m (7.0 kg-m, 50.5 lb-ft)
6A4-78 ENGINE MECHANICAL