Suzuki RA410, Manual

Page: 487 / 761

7
ASSEMBLY
1) If end housing bearing (1) is removed, install it.
2) Check end housing bearing turns smoothly.
3) If stator (1) is removed, install stator and tighten stud bolts (2).
4) If drive end bearing (3) is removed, install it.
5) Check drive end bearing turns smoothly.
Tightening Torque
(a): 8.7 N
.
m (0.87 kg-m, 6.5 lb-ft)
(b): 2.6 N
.
m (0.26 kg-m, 2.0 lb-ft)
2 (a)
1
3
(b)
6) Place drive end frame (1) on pulley, and then install rotor (2) to
drive end frame.
2
1
7) Install rear end frame (1) to drive end frame (2).
8) Tighten 2 nuts and 2 bolts to specified torque.
Tightening Torque
(c): 4.5 N
.
m (0.45 kg-m, 3.5 lb-ft)
(c)
1
2
(c)
9) Install pulley (1) and tighten pulley nut with holding shaft using
hexagonal box wrench (2) to specified torque.
Tightening Torque
(d): 113 N
.
m (11.3 kg-m, 81.5 lb-ft)
1
2
(d)
6H-18 CHARGING SYSTEM