Suzuki RA410, Manual

Page: 39 / 761

ITEM 6-6
Manual Transmission Oil Inspection and Change
[Inspection]
1) Inspect transmission case for evidence of oil leakage.
Repair leaky point if any.
2) Make sure that vehicle is placed level for oil level check.
3) Remove oil filler/level plug (1) of transmission.
4) Check oil level.
Oil level can be checked roughly by means of filler/level plug
hole. That is, if oil flows out of level plug hole or if oil level is found
up to hole when level plug is removed, oil is properly filled.
If oil is found insufficient, pour specified oil up to level hole.
For specified oil, refer to description of oil change under On-Ve-
hicle Service in Section 7A.
5) Apply sealant to filler/level plug and tighten it to specified torque.
[Change]
1) Place the vehicle level and drain oil by removing drain plug (2).
2) Apply sealant to drain plug after cleaning it and tighten drain
plug to specified torque.
3) Pour specified oil up to level hole.
4) Tighten filler plug to specified torque.
For recommended oil, its amount and tightening torque data, re-
fer to On-Vehicle Service of Section 7A.
1
2
ITEM 6-7
Automatic Transmission
[Fluid level inspection]
1) Inspect transmission case for evidence of fluid leakage.
Repair leaky point, if any.
2) Make sure that vehicle is placed level for fluid level check.
3) Check fluid level.
For fluid level checking procedure, refer to Section 7B and be
sure to perform it under specified conditions. If fluid level is low,
replenish specified fluid.
1. Fluid level gauge
2. FULL HOT mark
3. LOW HOT mark
1
2
3
1
MAINTENANCE AND LUBRICATION 0B-15