Suzuki RA410, Manual

Page: 321 / 761

3) When installing piston and connecting rod assembly into cylin-
der bore, point arrow mark on piston head to crankshaft pulley
side.
1. Crankshaft pulley side
2. Flywheel side
4) Install piston and connecting rod assembly into cylinder bore.
Use special tool (Piston ring compressor) to compress rings.
Guide connecting rod into place on crankshaft.
Using a hammer handle, tap piston head to install piston into
bore. Hold ring compressor firmly against cylinder block until all
piston rings have entered cylinder bore.
Special Tool
(A): 09916-77310
5) Install bearing cap (1):
Point arrow mark on cap (2) to crankshaft pulley side.
Tighten cap nuts to specification.
Tightening Torque
(a): 33 N
.
m (3.3 kg-m, 24.0 lb-ft)
Crankshaft
pulley side
(a)
1
2
6) Reverse removal procedure for installation, as previously out-
lined.
7) Check to ensure that all removed parts are back in place. Rein-
stall any necessary parts which have not been reinstalled.
8) Install engine assembly to vehicle as previously outlined.
6A4-62 ENGINE MECHANICAL