Suzuki RA410, Manual

Page: 75 / 761

INSTALLATION
1) Install magnet clutch coil.
Protrusion on under side of coil ring must match hole in com-
pressor assembly to prevent movement ant correctly locate
lead wire.
2) Using special tool (C), install snap ring as shown.
Special Tool
(C): 09900-06107
3) Clamp covering portion of lead wire.
1. Snap ring
2. Clutch coil
2. Compressor
assembly
4) Install magnet clutch.
(1) Set magnet clutch squarely over clutch installation boss.
(2) Place special tool (D) onto clutch bearing.
Ensure that edge rests only on inner race of bearing.
(3) Install snap ring.
Special Tool
(D): 09991-06010
CAUTION:
Be careful not to scratch bearing seal.
5) Adjust clearance, between armature plate and magnet clutch
by putting shim on compressor shaft.
Standard clearance “a”: 0.3 – 0.6 mm (0.012 – 0.024 in.)
6) Tighten new armature plate nut as specified below.
Tightening Torque
(a): 14 N·m (1.4 kg-m, 10.5 lb-ft)
Special Tool
(A): 09991-06020
1. Armature plate
2. Screw
3. Washer
AIR CONDITIONING (OPTIONAL) 1B-23