Suzuki RA410, Manual

Page: 683 / 761

REAR DOOR LOCK ASSEMBLY
REMOVAL
1) Raise window all the way up.
2) Remove door trim and door sealing cover, refer to step 1) to 6)
of REAR DOOR GLASS REMOVAL in this section.
3) Disconnect door lock control rod (1).
4) Disconnect door opening control rod (2).
5) Disconnect push lever (3).
6) Remove lock assembly.
INSTALLATION
Reverse removal procedure to install rear door lock, noting points
mentioned in “FRONT DOOR LOCK ASSEMBLY”.
3
1
2
BACK DOOR ASSEMBLY
REMOVAL
1) Remove back door trim.
2) Disconnect key cylinder rod (1).
3) Remove lock assembly (2) and key cylinder assembly (3).
2
3
1
INSTALLATION
To install back door lock, reverse removal procedure, noting follow-
ings points.
Make sure that door latch striker (1) center aligns with the center
of groove “A” in door lock (2) as shown in figure.
To adjust door lock (2) and door latch striker (1) each other, insert
proper number of shims (3) below the bottom of door latch striker
(1).
“A”
2
3
1
BODY SERVICE 9-41