Suzuki RA410, Manual

Page: 500 / 761

DIFFERENTIAL SIDE OIL SEAL
REPLACEMENT
1) Lift up vehicle and drain transmission oil.
2) Remove drive shaft joints from differential gear of transmission.
Refer to Section 4A (DRIVE SHAFT) for procedure to discon-
nect drive shaft joints.
For differential side oil seal removal, it is not necessary to re-
move drive shafts from steering knuckle.
3) Remove differential side oil seal by using screwdriver or like.
4) Press fit a new differential side oil seal (1) with spring side in-
ward using plate (2) and special tool with hammer up to the posi-
tion below.
Distance “a”: 1.0 – 1.5 mm (0.04 – 0.06 in.)
Diameter “b”: 56 mm (1.38 in.) (Right side)
60 mm (2.36 in.) (Left side)
Special Tool
(A): 09913-75510
5) Apply grease to oil seal lip and at the same time check drive
shaft where oil seal contacts and make sure of its smoothness.
“A”: Grease 99000-25010
6) Insert drive shaft joint to transmission referring to SECTION 4A.
7) Fill transmission fluid as specified and make sure that oil has
been sealed with oil seal.
(A)
2
1, “A”
(A)
1, “A”
2
2
1
2
[Right side]
[Left side]
MANUAL TRANSMISSION 7A-7