WHEEL HUB AND STEERING KNUCKLE
1. Front wheel hub
2. Circlip
3. Wheel bearing
4. Steering knuckle
5. Drive shaft nut
: Calk, after tightening.
6. Hub bolt
4
3
2
1
6
175 N·m (17.5 kg-m)
: Tightening Torque
: Do not reuse
5
REMOVAL
1) Hoist vehicle and remove wheel.
2) Uncaulk drive shaft nut (1).
3) Depress foot brake pedal and hold it there. Remove drive shaft
nut (1).
4) Remove caliper carrier bolts.
CAUTION:
Never reuse drive shaft nut (1).
5) Remove caliper (1) with carrier.
NOTE:
Hang removed caliper with a wire hook or the like so as to
prevent brake hose from bending and twisting excessively
or being pulled.
Don’t operate brake pedal with pads removed.
6) Pull brake disc (2) off by using two 8 mm bolts.
1
2
7) Pull out wheel hub (1) with special tools.
Special Tool
(A): 09943-17912
(B): 09942-15510
3D-12
FRONT SUSPENSION
Summary of Contents for RA410
