Suzuki RA410, Manual

Page: 714 / 761

AIR BAG SYSTEM 10B-19
Table D – “AIR BAG” WARNING LAMP CANNOT INDICATE DTC BY FLASHING
STEP ACTION YES NO
1 1) Inspect connection between diagnostic switch
terminal on “AIR BAG” monitor coupler and
body ground by service wire.
2) Is it securely connected between them by ser-
vice wire?
Go to Step 2. Properly connection
diagnostic switch termi-
nal on “AIR BAG” moni-
tor coupler and body
ground by service wire.
2 1) Disconnect SDM (“A”) connector.
2) Check for proper connection at “V” wire
((“A15”) terminal of SDM (“A”) connector and
terminal on “AIR BAG” monitor coupler (1))
terminals.
3) If OK then measure resistance between “V”
wire circuit terminals.
4) Is resistance 1 or more?
Check “V” wire terminals.
If OK then “V” wire circuit
high resistance or open.
Substitute a known-
good SDM and recheck
Fig. for Step 2
Special Tool
(A): 09932-76010
NOTE:
Upon completion of inspection and repair work, perform following items.
1) Reconnect all air bag system components, ensure all components are properly mounted.
2) Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK to confirm that the trouble has been corrected.