2) Lift valve by turning crankshaft and then remove camshaft
housing bolts (1) where the shim is to be replaced.
3) Install special tool with camshaft housing bolts as shown in fig-
ure.
Special Tool
(A): 09916-67010
NOTE:
Check that shim is not under pressure of special tool.
4) Turn camshaft by approximately 90
clockwise and remove
shim (4).
1. Tappet
2. Flat tip screwdriver
3. Special tool
3
2
4
1
5) Measure thickness of removed shim (1) and calculate thickness
of shim to be installed.
A = B + C – 0.20 mm
A : Thickness of new shim to be installed (mm)
B : Removed shim thickness
(mm)
C : Valve clearance as measured
(mm)
6) Select new shim from the following thickness and install it to tap-
pet.
NOTE:
When installing shim, make sure to direct its size mark to-
ward tappet.
Shim thickness (mm):
7) Lift valve by turning crankshaft in opposite direction and remove
special tool (3).
3
1
2
1. Tappet
2. Camshaft
6A4-10
ENGINE MECHANICAL
2.18
2.30
2.42
2.54
2.66
2.78
2.90
2.20
2.32
2.44
2.56
2.68
2.80
2.92
2.22
2.34
2.46
2.58
2.70
2.82
2.94
2.24
2.36
2.48
2.60
2.72
2.84
2.96
2.26
2.38
2.50
2.62
2.74
2.86
2.98
2.28
2.40
2.52
2.64
2.76
2.88
3.00
Summary of Contents for RA410
