Suzuki RA410, Manual

Page: 732 / 761

AIR BAG SYSTEM 10B-37
DTC 44 – DRIVER PRETENSIONER INITIATOR CIRCUIT SHORT TO POWER CIRCUIT and 48 – PAS-
SENGER PRETENSIONER INITIATOR CIRCUIT SHORT TO POWER CIRCUIT
STEP ACTION YES NO
1 1) With ignition switch OFF, remove center pillar
inner garnish of applicable side then discon-
nect seat belt pretensioner (“F” or “G”) con-
nector.
2) Check proper connection to applicable seat
belt pretensioner at terminals in “F” or “G”
connector.
3) If OK then connect Special Tool (B) to seat
belt pretensioner (“F” or “G”) connector dis-
connected at the step 1).
4) With ignition switch ON, is DTC 44 or 48 still
current?
Go to Step 2. 1) Ignition switch OFF.
2) Replace seat belt pre-
tensioner (retractor
assembly) (Refer to
SECTION 10).
2 1) With ignition switch OFF, disconnect Special
Tool (B) and SDM (“A”) connector.
2) Measure voltage from “A12” or “A5” terminal
to body ground.
3) With ignition switch ON, is voltage 1 V or
less?
Substitute a known-good
SDM and recheck.
DTC44:
Repair short “G/O” or
“G/Y” wire circuit to pow-
er circuit.
DTC48:
Repair short from “Bl/O”
or “Bl/Y” wire circuit to
power circuit.
Fig. for Step 1 and 2
“F”, “G”
(B)
Fig. for Step 2
For DTC 44
For DTC 48
“A5”
Special Tool
(A): 09932-76010
(B): 09932-75010
NOTE:
Upon completion of inspection and repair work, perform following items.
1) Reconnect all air bag system components, ensure all components are properly mounted.
2) Clear diagnostic trouble codes (Refer to DIAGNOSTIC TROUBLE CODE (DTC) CLEARANCE), if any.
3) Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK to confirm that the trouble has been corrected.