Suzuki RA410, Manual

Page: 704 / 761

AIR BAG SYSTEM 10B-9
AIR BAG DIAGNOSTIC SYSTEM CHECK
WARNING:
To avoid deployment when troubleshooting the air bag system, do not use electrical test equipment
such as a battery powered or AC powered voltmeter, ohmmeter, etc., or any type of electrical equip-
ment other than that specified in SPECIAL TOOLS of this section. Do not use a non-powered probe
type tester.
Instructions in this section must be followed carefully, otherwise personal injury may result.
CAUTION:
The order in which diagnostic trouble codes are diagnosed is very important. Failure to diagnose
the diagnostic trouble codes in the order specified may result in extended diagnostic time, incorrect
diagnosis and incorrect parts replacement.
The diagnostic procedures used in this section are designed to find and repair air bag system malfunctions.
To get the best results, it is important to use the diagnostic flow tables and follow the sequence listed below.
A. Perform the AIR BAG DIAGNOSTIC SYSTEM CHECK FLOW TABLE.
The AIR BAG DIAGNOSTIC SYSTEM CHECK FLOW TABLE must be the starting point of any air bag system
diagnosis.
The AIR BAG DIAGNOSTIC SYSTEM CHECK FLOW TABLE checks for proper “AIR BAG” warning lamp op-
eration through “AIR BAG” warning lamp and whether air bag diagnostic trouble codes exist.
B. Refer to the proper diagnostic table as directed by the AIR BAG DIAGNOSTIC SYSTEM CHECK FLOW TABLE.
The AIR BAG DIAGNOSTIC SYSTEM CHECK FLOW TABLE will lead you to the correct table to diagnose any
air bag system malfunctions. Bypassing these procedures may result in extended diagnostic time, incorrect
diagnosis and incorrect parts replacement.
C. Repeat the AIR BAG DIAGNOSTIC SYSTEM CHECK FLOW TABLE after any repair or diagnostic procedures
have been performed.
Performing the AIR BAG DIAGNOSTIC SYSTEM CHECK FLOW TABLE after all repair or diagnostic proce-
dures will ensure that the repair has been made correctly and that no other malfunctions exist.
FLOW TABLE TEST DESCRIPTION
STEP1:Check that “AIR BAG” warning lamp lights.
STEP2:Check that “AIR BAG” warning lamp lights.
STEP3:Check diagnosis switch circuit.
STEP4:Check that “AIR BAG” warning lamp flashes 6 times after ignition switch is turned ON.
STEP5:Check that history codes are in SDM memory.
STEP6:Check that current code is in SDM memory.