Suzuki RA410, Manual

Page: 217 / 761

INSPECTION
Brake Pad
Check pad lining for wear. When wear exceeds limit, replace with
new one.
Pad thickness (lining thickness)
Standard : 10 mm (0.40 in.)
Limit
: 2 mm (0.08 in.)
NOTE:
When pads are removed, visually inspect caliper for brake
fluid leak. Correct leaky point, if any.
CAUTION:
Never polish pad lining with sandpaper. If lining is pol-
ished with sandpaper, hard particles of sandpaper will be
deposited in lining and may damage disc. When pad lin-
ing requires correction, replace it with a new one.
INSTALLATION
1) Set brake pad springs (1) and shim (2) and install brake pads
(3).
2
1
3
2) Install caliper and tighten caliper pin bolt (1) to specified torque.
Tightening Torque
(a): 27 N·m (2.7 kg-m, 19.0 lb-ft)
3) Tighten wheel temporarily and lower lift.
4) Tighten wheel nuts to specified torque.
Tightening Torque
(a): 85 N·m (8.5 kg-m, 61.5 lb-ft)
5) After completion of installation, check for brake effectiveness.
(a)
BRAKES 5-13