Suzuki RA410, Manual

Page: 414 / 761

ON-VEHICLE SERVICE
GENERAL
When the emission control hoses are disconnected and the sys-
tem’s components are removed for service, reinstall them properly.
After service, making sure that hoses are routed and connected
correctly. Refer to Emission Control Information Label (if equipped)
for proper routing of hoses.
ECM/PCM
REMOVAL
1) Disconnect battery negative cable at battery.
2) If equipped with air bag system, disable air bag system referring
to DISABLING AIR BAG SYSTEM in SECTION 10B.
CAUTION:
As ECM/PCM consists of precision parts, be careful not
to expose it to excessive shock.
3) Open glove box, then while pressing glove box stopper, pull out
glove box from instrument panel.
4) Remove glove box (1).
1
5) Disconnect connectors from ECM/PCM.
6) Remove ECM/PCM (1) from body.
INSTALLATION
Reverse removal procedure noting the following.
Connect connectors to ECM/PCM securely.
If equipped with air bag system, be sure to enable air bag system
after installing ECM/PCM, referring to ENABLING AIR BAG
SYSTEM in SECTION 10B.
1
ENGINE AND EMISSION CONTROL SYSTEM 6E1-49