Suzuki RA410, Manual

Page: 752 / 761

b) Place special tool (passenger air bag (inflator) module de-
ployment fixture) on the ground in the space cleared in step
i), if it has not already been placed there.
Special Tool
(B): 09932-75041 or 09932-75040 and 09932-75050
c) Fill plastic reservoir in fixture (special tool) with water or
sand. This is necessary to provide sufficient stabilization of
the fixture during deployment.
d) Attach the passenger air bag (inflator) module in the fixture
(special tool) using mounting attachment, hold-down bolts
and nuts and M8 bolts and nuts (1).
Securely hand-tighten all fastener prior to deployment.
CAUTION:
Be sure to use the following bolt and nut for fixing
passenger air bag (inflator) module to mounting at-
tachment. Size: M8, Strength: 7T
1
(B)
[In case of seat belt pretensioner]
a) Pull out the webbing (2) fully as shown in the figure and cut
it at the root of the pretensioner (retractor assembly) (1) as
shown in the figure.
b) Clear a space on the ground about 185 cm (6 ft) (4) in diame-
ter where the seat belt pretensioner (1) is to be activated. A
paved, outdoor location where there is no activity is pre-
ferred. If an outdoor location is not available, a space on the
shop floor where there is no activity and sufficient ventilation
is recommended.
Ensure no loose or flammable objects are within the activa-
tion area.
c) Place the seat belt pretensioner (retractor assembly) (1) as
shown in the figure on the ground in the space just cleared.
WARNING:
As the drum (3) of the retractor assembly (1) turns
very quickly as soon as the webbing (2) is cut, fix
the retractor assembly (1) with a vise on the work-
bench and keep your hands and fingers away from
it when cutting the webbing (2).
3
1
4
AIR BAG SYSTEM 10B-57