Suzuki RA410, Manual

Page: 586 / 761

AUTOMATIC TRANSMISSION 7B-59
1. Screwdriver
LEFT SIDE
RIGHT SIDE
(D)
(E)
1
2
(D)
(E)
2
3) Remove L bearing by using puller while supporting its center
shaft.
4) Support differential case (1) with soft jawed vise and remove fi-
nal gear bolts then take out final gear.
5) Using special tool and hammer, drive out differential side pinion
shaft pin and then disassemble component parts.
Special Tool
(C): 09922-85811
ASSEMBLY
Asselmbly in reverse order of disassembly, nothing the following.
Assembly differntial gear (2) and measure thrust play of differential
gear as follows.
Differential gear thrust play:
0.03 – 0.04 mm (0.0012 – 0.015 in)
Available thrust washer thickness:
0.90, 0.95, 1.00, 1.05, 1.10, 1.15, 1.20 mm (0.035, 0.037, 0.039,
0.041, 0.043, 0.045, 0.047 in.)
Special Tool
(D): 09900-20606
(E): 09900-20701
Install exciter ring (2), directing as shown.
Press-fit bearings (1) by using special tool and copper hammer.
Special Tool
(F): 09951-76010
(G): 09951-16060