Suzuki RA410, Manual

Page: 647 / 761

FRONT DOOR WINDOW REGULATOR
REMOVAL
1) Remove door glass, referring to steps 1) to 10) of FRONT
DOOR GLASS REMOVAL in this section.
2) Disconnect power window motor lead wire at coupler and loos-
en clamp (if equipped).
3) Loosen regulator mounting screws (1) and take out regulator
through hole as shown in left figure.
1
1
INSPECTION
1) Check regulator sliding and rotating parts for greasing (1).
2) Check rollers (2) for wear and damage.
1
1
1
1
2
INSTALLATION
Reverse removal procedure to install window regulator noting the
following point.
When installing glass, check that the top part of the glass con-
tacts the glass run evenly and that the glass moves up and down
smoothly.
If the glass is tilted with respect to the glass run, adjust equalizer
(1) of window regulator so that measurement A and B are equal.
B
A
1
BODY SERVICE 9-5