Suzuki RA410, Manual

Page: 250 / 761

6-6 ENGINE
ENGINE DIAGNOSTIC FLOW TABLE
Refer to the following pages for the details of each step.
STEP ACTION YES NO
1 Customer Complaint Analysis
1) Perform customer complaint analysis.
Was customer complaint analysis performed?
Go to Step 2. Perform customer
complaint analysis.
2 Diagnostic Trouble Code (DTC) Check, Record and
Clearance
1) Check for DTC referring to DTC CHECK in
SECTION 6E1.
Is there any malfunction DTC(s)?
1) Print DTC or
write it down and
clear it by refer-
ring to DTC
CLEARANCE in
SECTION 6E1.
2) Go to Step 3.
Go to Step 4.
3 Visual Inspection
1) Perform visual inspection referring to VISUAL
INSPECTION in this section.
Is there any faulty condition?
1) Repair or replace
malfunction part.
2) Go to Step 11.
Go to Step 5.
4 Visual Inspection
1) Perform visual inspection referring to VISUAL
INSPECTION in this section.
Is there any faulty condition?
1) Repair or replace
malfunction part.
2) Go to Step 11.
Go to Step 8.
5 Trouble Symptom Confirmation
1) Confirm trouble symptom referring to
TROUBLE-SYMPTOM CONFIRMATION in this
section.
Is trouble symptom identified?
Go to Step 6. Go to Step 7.
6 Rechecking and Record of DTC
1) Recheck for DTC referring to DTC CHECK in
SECTION 6E1.
Is there any DTC(s)?
Go to Step 9. Go to Step 8.
7 Rechecking and Record of DTC
1) Recheck for DTC referring to DTC CHECK in
SECTION 6E1.
Is there any malfunction DTC(s)?
Go to Step 9. Go to Step 10.
8 Engine Basic check and Engine Diagnosis Table
1) Check and repair according to ENGINE BASIC
CHECK AND ENGINE DIAGNOSIS TABLE in this
section.
Are check and repair complete?
Go to Step 11. 1) Check and repair
malfunction
part(s).
2) Go to Step 11.
9 Troubleshooting for DTC
1) Check and repair according to applicable DTC diag.
flow table in SECTION 6E1.
Are check and repair complete?
Go to Step 11. 1) Check and repair
malfunction
part(s).
2) Go to Step 11.
10 Check for Intermittent Problems
1) Check for intermittent problems referring to CHECK
FOR INTERMITTENT PROBLEM in this section.
Is there any faulty condition?
1) Repair or replace
malfunction
part(s).
2) Go to Step 11.
Go to Step 11.
11 Final Confirmation Test
1) Clear DTC, if any.
2) Perform final confirmation test referring to FINAL
CONFIRMATION TEST in this section.
Is there any problem symptom, malfunction DTC or abnor-
mal condition?
Go to Step 6. End.