Suzuki RA410, Manual

Page: 503 / 761

TRANSMISSION ASSEMBLY
DISMOUNTING
1) Disconnect negative cable at battery.
2) Remove battery and its tray.
3) Remove air cleaner box.
4) Disconnect gearshift control cable (1) and gear select control
cable (2).
5) Remove E rings (3) and transmission control cable bracket (4).
6) Undo wiring harness clamps.
7) Disconnect the following couplers and cables.
Back up lamp switch
Vehicle speed sensor (VSS)
Ground cable
Starter motor cable
2
3
1
4
8) Remove starting motor taking out its 2 bolts.
9) Support engine with engine support jack (1) as shown in left
figure.
10) Remove upper side 2 transmission to engine bolts.
1
11) Remove front wheels (right & left).
12) Drain transmission oil.
13) Remove clutch release arm bolt and nut (1) and then detach
clutch cable (2) with clutch release arm (3).
14) Remove front stabilizer.
15) Remove front side exhaust pipe bolts, and then detach ex-
haust pipe from exhaust manifold.
16) Remove ball stud bolt from knuckles (right & left), and then dis-
connect each front suspension control arm ball stud from
steering knuckle.
17) By using large size screwdrivers (1), pull out drive shaft joint
(2) at differential side.
2
2
1
3
1
7A-10 MANUAL TRANSMISSION