Suzuki RA410, Manual

Page: 639 / 761

WASHER LINKED OPERATION INSPECTION
1) Disconnect negative cable (–) at battery.
2) Disconnect combination switch lead wire coupler.
3) Make sure that front wiper switch is at OFF position.
4) Connect battery positive terminal (+) to terminal “B3” and bat-
tery negative terminal (–) to terminal “HE”.
5) Connect voltmeter positive lead to terminal “+1” and negative
lead to terminal “HE”.
6) Push washer switch check that voltage changes as shown in
the table.
HE
FRONT WIPER MOTOR
INSPECTION
1) As illustrated left, have a 12V battery and connect its (+) termi-
nal to terminal “A”, and its (–) terminal to bracket (wiper ground).
If motor rotates at a low revolution speed of 44 to 52 rpm, it is
proper. As for high speed check, connect battery (+) terminal to
terminal “B”, and its (–) terminal to bracket (wiper ground). If mo-
tor rotates at a high revolution speed of 64 to 78 rpm, it is proper.
A
C B
D
2) Testing automatic stop action
a) Connect 12V battery (+) terminal to terminal “A” of wiper mo-
tor and (–) terminal to bracket (wiper ground) and let the mo-
tor turn.
b) Disconnect terminal “A” from battery, and let the motor stop.
c) Connect terminal “A” and “D” with a jumper wire, and con-
nect terminal “C” to battery (+) terminal. Observe the motor
turns once again then stops at a given position.
d) Repeat a) thru c) several times and inspect if the motor stops
at the given position every time.
A
C B
D
BODY ELECTRICAL SYSTEM 8-23