Suzuki RA410, Manual

Page: 633 / 761

SPEED METER/SENSOR
VEHICLE SPEED SENSOR
Refer to VEHICLE SPEED SENSOR in SECTION 6E of this manu-
al.
FUEL METER/FUEL LEVEL SENSOR
(GAUGE UNIT)
FUEL LEVEL METER
INSPECTION
1) Disconnect Y/R lead wire going to fuel level sensor.
2) Turn ignition switch ON, and check that fuel meter indicates E.
3) Turn ignition switch OFF.
4) Ground Y/R lead through a 3.4 W test bulb (1) as illustrated.
5) Turn ignition switch ON and check that bulb light up and pointer
(2) moves to F side.
6) Remove combination meter and remove screws D and E.
7) Check resistance between terminals by using an ohmmeter.
8) If inspection result in step 2), 5) and/or 7) is not as specified, re-
place fuel meter.
2
1
B/O
A
B
C
D
E
FUEL LEVER SENSOR (GAUGE UNIT)
INSPECTION
1) Remove fuel pump assembly (1) referring to Section 6C of this
manual.
2) Check that resistance between terminals (a) and (b) of fuel level
sensor changes with change of float position.
3) Check resistance between terminals (a) and (b) in individual
float position by using an ohmmeter.
If the measured value is out of specification, replace.
a
b
“c”
“d”
“e”
BODY ELECTRICAL SYSTEM 8-17
Terminal connection Resistance ( )
A – B Approx. 153
B – C Approx. 244
C – A Approx. 90
Float Position Resistance ( )
Full Upper “c” 54.7 mm (2.15 in.) 2 – 4
Middle (1/2) “d” 118.3 mm (4.66 in.) 29.5 – 35.5
Full Lower “e” 200.1 mm (7.88 in.) 119 – 121