Suzuki RA410, Manual

Page: 382 / 761

ENGINE AND EMISSION CONTROL SYSTEM 6E1-17
STEP ACTION YES NO
5 1) Remove MAP sensor.
2) Visually inspect MAP sensor air pressure inlet
passage for clogging.
Was any clogging found?
Clean air passage or re-
place as necessary.
Go to Step 6.
6 1) Perform MAP SENSOR INSPECTION in this
section.
Is voltage within specified value?
Poor connection of MAP
sensor connector termi-
nal.
If OK, substitute a
known-good ECM/PCM
and recheck.
Faulty MAP sensor.
NOTE:
Upon completion of inspection and repair work, perform DTC CONFIRMATION PROCEDURE in this sec-
tion and confirm that the trouble has been corrected.
Fig. for Step 2 Fig. for Step 3 Fig. for Step 4
Fig. for Step 5
“b”
“a”
“b”
“c”