Suzuki RA410, Manual

Page: 32 / 761

6) Add coolant to reservoir so that its level aligns with Full mark.
Then, reinstall cap to reservoir aligning match marks (1) on the
reservoir and cap.
Refer to Section 6B of this manual for coolant capacity.
CAUTION:
When changing engine coolant, use mixture of 50%
water and 50% ethylene-glycol base coolant (Anti-
Freeze/Anti-corrosion coolant) for the market where
ambient temperature falls lower than –16 C (3 F) in
winter and mixture of 70% water and 30% ethylene-
glycol base coolant for the market where ambient
temperature doesn’t fall lower than –16 C (3 F).
Even in a market where no freezing temperature is an-
ticipated, mixture of 70% water and 30% ethylene-gly-
col base coolant should be used for the purpose of
corrosion protection and lubrication.
1
ITEM 1-6
Exhaust System Inspection
WARNING:
To avoid danger of being burned, do not touch exhaust
system when it is still hot.
Any service on exhaust system should be performed
when it is cool.
When carrying out periodic maintenance or vehicle is raised for
other service, check exhaust system as follows:
Check rubber mountings for damage and deterioration.
Check exhaust system for leakage, loose connections, dents,
and damages.
If bolts or nuts are loose, tighten them to specification.
Refer to Section 6K for torque specification of bolts and nuts.
Check nearby body areas for damaged, missing or misposi-
tioned parts, open seams, holes, loose connections or other de-
fects which could permit exhaust fumes to seep into vehicle.
Make sure that exhaust system components have enough clear-
ance from underbody to avoid overheating and possible dam-
age to floor carpet.
Any defects should be fixed at once.
0B-8 MAINTENANCE AND LUBRICATION