Suzuki RA410, Manual

Page: 336 / 761

INSTALLATION
NOTE:
All parts to be installed must be thoroughly cleaned.
Be sure to oil crankshaft journals, journal bearings, thrust
bearings, crankpins, connecting rod bearings, pistons, pis-
ton rings and cylinder bores.
Journal bearings, connecting rods, rod bearings, rod bear-
ing caps, pistons and piston rings are in combination sets.
Do not disturb such combination and make sure that each
part goes back to where it came from, when installing.
1) Install main bearings to cylinder block.
Upper half of bearing (2), has an oil groove (3). Install it to cylin-
der block (1), and the other half without oil groove to lower
crankcase.
Make sure that two halves are painted in the same color.
2) Install thrust bearings (1) to cylinder block between No.2 and
No.3 cylinders. Face oil groove sides to crank webs.
3) Apply sealant to mating surface of crankcase continuously as
shown in figure.
“A”: Sealant 99000-31150
“A”
CAUTION:
Do not apply sealant to shaded area.
ENGINE MECHANICAL 6A4-77