Suzuki RA410, Manual

Page: 519 / 761

Right Side
Using similar procedure to above-mentioned procedure, set
dial gauge tip to gear (1) shoulder.
Move gear up and down by hand and read dial gauge.
Special Tool
(A): 09900-20606
(B): 09900-20701
Right side
2) If thrust play is out of specification, select suitable thrust washer
from among the following available size, install it and check
again that specified gear play is obtained.
3) Drive in differential pinion shaft (1).
4) Press-fit left bearing (2) using special tool and copper hammer.
Special Tools
(A): 09951-76010
2
1
5) Hold differential assembly with soft jawed vise (1), install final
gear (2) and then tighten it with 8 bolts (3) to specified torque.
CAUTION:
Use of any other bolts than specified ones is prohib-
ited.
Tightening Torque
(a): 90 N
•
m (9.0 kg-m, 65.0 lb-ft)
1 3
2
6) Install exciter ring (1), directing as shown.
7A-26 MANUAL TRANSMISSION
Available thrust
washer thickness 0.9, 1.0 and 1.1 mm
(0.035, 0.039 and 0.043 in.)
bearing (2) is floating, and then press-fit right bearing (3) using
special tool and copper hammer.
Special Tool
(A): 09951-76010
(B): 09951-16060
7) Support differential assembly as shown in left figure so as to left