Suzuki RA410, Manual

Page: 658 / 761

BODY STRUCTURE
FRONT DOOR ASSEMBLY
REMOVAL
1) Remove front fender.
2) Disconnect door harness lead wires at each coupler.
3) Remove stopper pin (1).
1
4) Support door panel using a jack with a piece of wood (1) placed
between jack and panel, as shown.
1
5) Remove door assy by loosening hinge mounting bolts (1).
1
INSTALLATION
Reverse removal procedure to install door assembly, noting the fol-
lowing point.
NOTE:
When replacing door, coat replacement door inside with wax
for proper anticorrosion treatment.
Refer to “UNDERCOATING / ANTI-CORROSION COMPOUND
APPLICATION AREA” in this section.
Adjust door latch striker position by referring to “FRONT DOOR
LOCK INSTALLATION” Section so that door is positioned correctly.
Adjust front door cushion so that door becomes flush with side
body.
After installation, open and close the door to check looseness.
Replace door open stopper pin when there is looseness.
When weatherstrip is hardened, water leak may develop.
In such case, replace it with new one.
9-16 BODY SERVICE