Suzuki SWIFT RS415 2017, Руководство по обслуживанию

Страница: 472 / 1257

4A-5 Brake Control System and Diagnosis:
Dragging brakes (A very
light drag is present in all
brakes immediately after
pedal is released) Master cylinder pistons not returning
correctly Replace master cylinder.
Restricted brake pipes or hoses Check for soft hoses or damaged pipes and
replace with new hoses and/or new brake
piping.
Incorrect parking brake adjustment on
rear brakes Check and adjust to correct specifications.
Weakened or broken return springs in
the brake Replace.
Sluggish parking brake cables or linkage Repair or replace.
Wheel cylinder or caliper piston sticking Repair as necessary.
Badly worn piston seal in caliper Replace piston seal.
Improper brake pedal free height Check brake pedal free height.
Pedal pulsation (Pedal
pulsates when depressed
for braking) Damaged or loose wheel bearings Replace wheel bearings.
Distorted steering knuckle or rear wheel
spindle Replace knuckle or rear wheel spindle.
Excessive disc lateral runout Check per instructions. If not within
specifications, replace or machine disc.
Parallelism between pad and disc not
within specifications Check per instructions. If not within
specifications, replace or machine disc.
Rear drums out of round Repair or replace drum as necessary.
Check runout.
Braking noise Glazed shoe linings, or foreign matters
stuck to linings Repair or replace shoe linings.
Worn or distorted shoe linings Replace shoe lining (or pad).
Loose front wheel bearings Replace wheel bearings.
Distorted backing plates or loose
mounting bolts Replace or retighten securing bolts.
Contact wear indicator to brake disc Replace pads.
Brake warning lamp lights
after engine start Parking brake applied Release parking brake and check that brake
warning lamp turns off.
Insufficient amount of brake fluid Add brake fluid.
Brake fluid leaking from brake line Investigate leaky point, correct it and add
brake fluid.
Brake warning lamp circuit faulty Repair circuit.
Malfunctioning EBD system, if equipped
with ABS. Check system referring to “EBD Warning Lamp
(Brake Warning Lamp) Comes ON Steady: in
Section 4E”.
Brake warning lamp turns
on when brake is applied Brake fluid leaking from brake line Investigate leaky point, correct it and add
brake fluid.
Insufficient amount of brake fluid Add brake fluid.
Brake warning lamp fails
to turn on even when
parking brake is applied Brake warning lamp circuit faulty Replace bulb or repair circuit.
ABS warning lamp turns
on after engine start (If
equipped) Malfunctioning ABS Check system referring to “ABS Check: in
Section 4E”.
ABS warning lamp turns
on when brake is applied
(If equipped) Malfunctioning ABS Check system referring to “ABS Check: in
Section 4E”.
ABS warning lamp does
not turn on for 2 sec. after
ignition switch has turned
ON (If equipped) Bulb burnt out Replace bulb.
Malfunctioning ABS Check system referring to “ABS Check: in
Section 4E”.
ABS warning lamp
flashes (If equipped) New ABS hydraulic unit / control module
assembly installed. Perform “ABS Hydraulic Unit Operation Check:
in Section 4E”.
Condition Possible cause Correction / Reference Item