Suzuki SWIFT RS415 2017, Руководство по обслуживанию

Страница: 559 / 1257

Automatic Transmission: 5A-19
NOTE:
*1: TCM does not desire turning on malfunction indicator lamp to ECM but DTC is stored in TCM
memory. This item can not be read generic scan tool.
DTC Check
S4RS0A5104006
NOTE:
The MIL is turned on when the ECM and/or
TCM detect malfunction(s). Each control
module stores diagnostic information as the
diagnostic trouble code (DTC) in its memory
and outputs the DTC to the scan tool.
Therefore, check both of the control modules
for any DTC with the scan tool because the
DTC stored in ECM and TCM is not read and
displayed at a time. However, each of the
control modules needs not to be checked
with the generic scan tool because the DTC
stored in ECM and TCM is read and displayed
at a time. In case using generic scan tool,
refer to “DTC Table: in Section 1A”.
1) Turn ignition switch to OFF position.
2) Connect scan tool to data link connector (DLC) (1).
Special tool
(A): SUZUKI scan tool
3) Turn ignition switch ON.
4) Read DTC, pending DTC and freeze frame data
according to instructions displayed on scan tool and
print it down. Refer to scan tool operator’s manual
for further details.
If communication between scan tool and TCM is not
possible, check if scan tool is communicable by
connecting it to TCM in another vehicle. If
communication is possible in this case, scan tool is
in good condition. Then check data link connector
and serial data line (circuit) in the vehicle with which
communication was not possible.
5) After completing the check, turn ignition switch off
and disconnect scan tool from data link connector.
DTC Clearance
S4RS0A5104007
WARNING:
When performing a driving test, select a safe
place where there is neither any traffic nor
any traffic accident possibility and be very
careful during testing to avoid occurrence of
an accident.
After repair or replace malfunction part(s), clear all DTCs
by performing the following procedure.
1) Connect SUZUKI scan tool to data link connector in
the same manner as when making this connection
for “DTC Check: ”.
2) Turn ignition switch ON.
3) Erase DTC and pending DTC according to
instructions displayed on scan tool. Refer to scan
tool operator’s manual for further details.
4) After completing the clearance, turn ignition switch
OFF and disconnect scan tool from data link
connector (DLC).
NOTE:
DTC and freeze frame data stored in TCM
memory are also cleared in the following
cases. Be careful not to clear them before
keeping their record.
• When power to TCM is cut off (by
disconnecting battery cable, removing
fuse or disconnecting TCM connectors).
• When the same malfunction (DTC) is not
detected again during 40 engine warm-up
cycles.
) P2763
Torque converter clutch pressure
control solenoid control circuit high Too much electric flow is detected on TCC
solenoid circuit.
1 driving cycle
) P2764
Torque converter clutch pressure
control solenoid control circuit low No electric flow is detected on TCC solenoid
circuit.
1 driving cycle
DTC No. Detecting item
Detecting condition
(DTC will set when detecting)
Driving cycle
when MIL lighted
1
(A)
I4RS0A510009-