Suzuki SWIFT RS415 2017, Руководство по обслуживанию

Страница: 417 / 1257

Front Suspension: 2B-7
2) Install compressing coil spring, and mate spring end
(2) with stepped part of spring lower seat (1) as
shown.
CAUTION:
End of coil spring must not interfere with
step of spring lower seat.
3) Install bump stopper onto strut rod. For installing
direction, refer to the figure in “Front Suspension
Construction: ”.
4) Pull strut rod as far up as possible and use care not
to allow it to retract into strut.
5) Install spring seat on coil spring and then spring
upper seat (1) aligning UTmark (3) on spring upper
seat and center of strut bracket (2).
6) Install bearing (3), strut support (2) and strut support
lower nut (1) in this sequence.
Tighten strut support lower nut (1) to specified
torque.
When tightening strut support lower nut, hold stud
with special tools.
Special tool
(A): 09900–00411 (socket)
(B): 09900–00414 (6 mm)
Tightening torque
Strut support lower nut (a): 50 N·m (5.0 kg-m,
36.5 lb-ft)
Front Strut Assembly Check
S4RS0A2206008
• Inspect strut for oil leakage, damage or deformation.
• If strut is found faulty, replace it as an assembly unit,
because it can not be disassembled.
• Inspect strut function referring to the following
procedures.
1) Check and adjust tire pressures as specified.
2) Bounce vehicle body 3 or 4 times continuously by
pushing front end on the side with strut to be
checked.
3) Apply the same amount of force at each push and
note strut resistance both when pushed and
rebounding.
4) Also, note how many times vehicle body rebounds
before coming to stop after hands are off. Do the
same for strut on the other side.
I4RS0A220011-
I4RS0A220012-
I4RS0A220013-
I4RS0A220014-