Suzuki SWIFT RS415 2017, Руководство по обслуживанию

Страница: 938 / 1257

8B-68 Air Bag System:
DTC Troubleshooting
Step Action Yes No
1 1) With ignition switch OFF, remove center pillar lower trim
of driver or passenger side and disconnect seat belt
pretensioner connector “L10” or “L36” (1).
2) Check proper connection to seat belt pretensioner at
terminals in “L10” or “L36” connector.
3) If OK, then connect special tools (A), (B) and (C) to “L10”
or “L36” connector disconnected in Step 1).
Special tool
(A): 09932-76010
(B): 09932-75010
(C): 09932-78310
4) Check SDM DTC.
With ignition switch ON, is DTC B1053 or B1057 still
indicated?
Go to Step 2. Ignition switch OFF.
Replace seat belt
pretensioner referring to
“Front Seat Belt
Removal and
Installation: in Section
8A”.
2 1) With ignition switch OFF, disconnect special tools (A),
(B) and (C) and SDM connector.
2) Release shorting bar in SDM connector inserting release
tool (1) included in special tool (A).
3) Measure resistance between “L29-6” and body ground,
and between “L29-7” and body ground (for DTC B1053)
or between “L29-8” and body ground, and between “L29-
9” and body ground (for DTC B1057).
Special tool
(A): 09932-76010
Is resistance infinity?
Substitute a known-
good SDM and recheck. DTC B1053: “PNK”
circuit or “WHT” circuit
shorted to ground.
DTC B1057: “BRN”
circuit or “LT GRN”
circuit shorted to
ground.
STEERING WHEEL
(B)
(C)
(A)
"L10", "L36"
I4RS0A820027-
"L29-7" "L29-8" "L29-9" "L29-6"
(A)
STEERING WHEEL
(B)
(C)
(A)
"L10", "L36"
I4RS0A820029-