Suzuki SWIFT RS415 2017, Руководство по обслуживанию

Страница: 780 / 1257

6C-7 Power Assisted Steering System:
)
C1118
Torque sensor failure (signal voltage low)
Voltage at “E52-16” terminal is higher than
upper limit voltage for P/S control module
diagnosis for specified period or longer
1 driving
cycle
) C1119
Torque sensor 12 V power supply circuit
failure
Voltage at “E52-8” terminal (12 V) is lower
than lower limit voltage for P/S control
module diagnosis for specified period or
longer
1 driving
cycle
)
C1121
VSS circuit signal not input (60 seconds
or more)
No vehicle speed signal is inputted to P/S
control module in either one of the
following two conditions
1. More than 60 seconds pass at more
than 4000 rpm engine speed before a
lapse of 5 minutes from the engine
start
2. More than 60 seconds pass at more
than 2500 rpm engine speed after a
lapse of 5 minutes from the engine
start
1 driving
cycle
) C1122 Engine speed signal circuit failure
P/S control module detects all the
following conditions for 20 seconds or
more
• Vehicle speed signal 60 km/h (37 mph)
or more
• Engine speed signal 220 rpm or less
1 driving
cycle
)
C1123
VSS circuit signal not input (30 seconds
or more)
No vehicle speed signal is inputted to P/S
control module in either one of the
following two conditions
1. More than 30 seconds pass at more
than 4000 rpm engine speed before a
lapse of 5 minutes from the engine
start
2. More than 30 seconds pass at more
than 2500 rpm engine speed after a
lapse of 5 minutes from the engine
start
3 driving
cycles
) C1124
VSS circuit failure (abnormal
deceleration)
Vehicle speed is inputted to P/S control
module as having decelerated by more
than specified deceleration and lower than
5 km/h vehicle speed continued for 5
seconds after deceleration
1 driving
cycle
) C1141 Motor circuit voltage abnormal
Voltage at “E51-1” terminal or “E51-2”
terminal differs from specified voltage for
P/S control module diagnosis for specified
period or longer
1 driving
cycle
) C1142
Motor circuit current high command with
P/S control module target current
Measured value of motor circuit current is
10 A or more higher than specified value
of motor circuit current from P/S control
module
1 driving
cycle
) C1143 Motor circuit current excessive
Measured value of motor circuit current is
50 A or more 1 driving
cycle
) C1145
Motor circuit current low command with
P/S control module target current
Measured value of motor circuit current is
lower than specified value of motor circuit
current from P/S control module
1 driving
cycle
) C1153
P/S control module power supply circuit
failure Battery voltage is lower than lower limit
voltage for P/S control module diagnosis 1 driving
cycle
DTC No. Detecting item
Detecting condition
(DTC will set when detecting)
MIL