Suzuki SWIFT RS415 2017, Руководство по обслуживанию

Страница: 310 / 1257

1D-47 Engine Mechanical:
Piston clearance
Measure cylinder bore diameter and piston diameter to
find their difference which is piston clearance. Piston
clearance should be within specification as follows. If it is
out of specification, rebore cylinder and use oversize
piston.
NOTE:
Cylinder bore diameters used here are
measured in thrust direction at two positions.
Piston clearance
Standard: 0.032 – 0.061 mm (0.0013 – 0.0024 in.)
Standard (piston with coating (new one)): 0.016 –
0.045 mm (0.0006 – 0.0018 in.)
Limit: 0.161 mm (0.0065 in.)
Ring groove clearance
Before checking, piston grooves must be clean, dry and
free of carbon deposits.
Fit new piston ring (1) into piston groove, and measure
clearance between ring and ring land by using thickness
gauge (2). If clearance is out of specification, replace
piston.
Ring groove clearance
Piston Ring
Piston ring end gap
To measure end gap, insert piston ring (2) into cylinder
bore and then measure the gap by using thickness
gauge (1).
If measured gap exceeds limit, replace ring.
NOTE:
Decarbonize and clean top of cylinder bore
before inserting piston ring.
Piston ring end gap
“a”: 19.5 mm (0.77 in.)
Standard Limit
Top ring
0.03 – 0.07 mm
(0.0012 – 0.0028 in.)
0.12 mm (0.0047 in.)
2nd ring
0.02 – 0.06 mm
(0.0008 – 0.0024 in.)
0.10 mm (0.0039 in.)
Oil ring
0.03 – 0.17 mm
(0.0012 – 0.0067 in.)
—
I4RS0A140022-
Item Standard Limit
Top ring
0.20 – 0.35 mm
(0.0079 – 0.0138 in.)
0.7 mm (0.0276 in.)
2nd ring
0.35 – 0.50 mm
(0.0138 – 0.0197 in.)
1.0 mm (0.0394 in.)
Oil ring
0.20 – 0.70 mm
(0.0079 – 0.0276 in.)
1.2 mm (0.0472 in.)
“a”: 120 mm (4.72 in.)
I2RH01140159-
I2RH01140161-