Suzuki SWIFT RS415 2017, Руководство по обслуживанию

Страница: 475 / 1257

Brake Control System and Diagnosis: 4A-8
2) Remove bleeder plug cap. Attach a vinyl tube (1) to
bleeder plug, and insert the other end into container
(2).
3) Depress brake pedal several times, and then while
holding it depressed, loosen bleeder plug about one-
third to one-half turn.
4) When fluid pressure in cylinder is almost depleted,
retighten bleeder plug.
5) Repeat this operation until there are no more air
bubbles in hydraulic line.
6) When bubbles stop, depress and hold brake pedal
and tighten bleeder plug.
Tightening torque
Front brake caliper bleeder plug: 8.0 N·m (0.8
kg-m, 6.0 lb-ft)
Rear wheel cylinder bleeder plug: 7.5 N·m (0.75
kg-m, 5.5 lb-ft)
7) Then attach bleeder plug cap.
8) After completing bleeding operation, apply fluid
pressure to pipe line and check for leakage.
9) Replenish fluid into reservoir up to specified level.
10) Check brake pedal for sponginess. If found spongy,
repeat entire procedure of bleeding.
Front Brake Hose / Pipe Removal and
Installation
S4RS0A4106007
Removal
1) Raise and support vehicle properly. Remove tire and
wheel.
NOTE:
This operation is not necessary when
removing pipes connecting master cylinder.
2) Clean dirt and foreign material from both flexible
hose end and pipe end fittings.
3) Remove brake flexible hose or pipe.
Installation
Reverse brake flexible hose installation procedure,
noting the following.
• Make sure that steering wheel is in straight-forward
position and flexible hose has not twist or kink.
• Check to make sure that flexible hose doesn’t contact
any part of suspension, both in extreme right and
extreme left turn conditions. If it does at any point,
remove and correct. Fill and maintain brake fluid level
in reservoir.
• Bleed brake system. Refer to “Air Bleeding of Brake
System: ”.
I4RS0A410008-
I2RH01410015-
I2RH01410016-
I2RH01410017-
I4RS0A410008-