Suzuki SWIFT RS415 2017, Руководство по обслуживанию

Страница: 770 / 1257

6B-5 Steering Wheel and Column:
4) From the position where contact coil became unable
to turn any further (it stopped), turn it back clockwise
about two and a half rotations and align center mark
with alignment mark (1).
Contact Coil Cable Assembly Inspection
S4RS0A6206004
Check contact coil cable assembly wire harness for any
signs of scorching, melting or other damage.
If it is damaged, replace.
Steering Column Removal and Installation
S4RS0A6206005
CAUTION:
Once the steering column is removed from
the vehicle, the column is extremely
susceptible to damage.
• Dropping the column assembly on its end
could collapse the steering shaft or loosen
the plastic shear pins which maintain
column length.
• Leaning on the column assembly could
cause it to bend or deform.
Any of the damage could impair the column’s
collapsible design.
Steering column mounting nuts should not
be loosened with steering shaft joint upper
side bolt tightened as this could cause
damage to shaft joint bearing.
NOTE:
When servicing steering column or any
column-mounted component, remove
steering wheel. But when removing steering
column simply to gain access to instrument
panel components, leave steering wheel
installed on steering column.
Removal
WARNING:
Never rest a steering column assembly on
the steering wheel with the air bag (inflator)
module face down and column vertical.
Otherwise, personal injury may result.
1) Disconnect negative (–) battery cable at battery
terminal.
2) Disable air bag system. Refer to “Disabling Air Bag
System: in Section 8B”.
3) Remove steering wheel and contact coil cable
assembly referring to “Steering Wheel Removal and
Installation: ” and “Contact Coil Cable Assembly
Removal and Installation: ”.
4) Detach lighting switch and wiper switch from steering
column.
5) Remove immobilizer control module (if equipped)
from steering column.
6) Remove ignition switch cylinder assembly (1) as
follows.
a) Turn ignition switch key to ACC position.
b) Insert 2 mm (0.078 in.) rod (2) through hole (3)
and push ignition switch cylinder lock.
7) Detach ignition switch assembly from steering
column.
8) Remove steering column hole cover.
9) Remove steering joint cover.
10) Make alignment marks (4) on lower shaft (1) and
shaft joint of steering column (2) and lower shaft (1)
and pinion shaft (3) for a guide during reinstallation.
11) Remove lower shaft joint bolts (5).
12) Remove steering lower shaft (1).
1
I4RS0A620013-
I4RS0A620014-
I4RS0A620015-