Televes OLT 769401, User Manual

Page: 51 / 482

EN
51
The FAN module can be replaced and is hot swappable. In order to replace the module, please refer to section FAN
4.6.1.1.1 LED Indicator
Each fan module has an LED, STATUS that must indicate the following states of the system:
•
Without OLT Ref.769401 (switch fabric) on the chassis, the fan module blinks RED.
•
The led remain to blink RED until the OLT Ref.769401 ( start (takes appx. 3 minutes).
•
If no problem occur, the LED must blinks GREEN (normal state), unless the environmental temperature e45C.
4.6.1.2 Air Filter
The OLT system has a single air filter located at the left side of the chassis.
Filter maintenance is dependent on the environmental air quality in which the system is installed.
The filter should be checked, at a minimum, annually (8760 hours) and cleaned or replaced if there is evidence of airflow blockage.
In environments with high particulate matter, the filter should be checked, cleaned or replaced more often. Should the filter require cleaning,
remove the filter from the server. See Removing the Air Filter. Take the filter to an open area and blow the particles from the filter using a can of
compressed air. Do not use a coarse brush or anything abrasive since they may damage the filter.
4.6.1.3 FAN Module Replacement Procedures
Important!
When performing OLT system service actions, observe electrostatic discharge (ESD) precautions; please refer to section 4.2 ESD Precautions
4.6.1.4 Air Filter Replacement Procedures
Important!
When performing OLT system service actions, observe electrostatic discharge (ESD) precaution; please refer
to section 4.2 ESD Precautions
Be sure to have a spare cleaned Air Filter in order to minimize the time that the system is working without air filtering.
A trained technician should execute the task in a few seconds.
4.6.1.4.1 Air Filter Removal
Step 1
Locate the Air filter at the chassis
Step 2 Hold the Air filter with both hands, pull it towards you and slide it out of the chassis