Televes OLT 769401, User Manual

Page: 56 / 482

Descripción del producto
56
5. Configuration
This chapter addresses the configuration of the equipment via local management.
5.1 System Management
The OLT equipment can be managed locally simply using a web browser; via Web Ti application or using a Linux based Command Line Interface,
CLI. The operation with the WebTi is described in the next sections of this manual. Option with CLI is described in section 7 CLI. Both WebTi and CLI
provide the system with Local Craft Terminal (LCT) functionalities.
There are two different ways to manage the equipment:
Connect to the management port (ETH), Figure 5-1
Inband Management (using a management VLAN), Figure 5-2
To manage the OLT equipments, the OLT Ethernet management port must be connected to the Service Provider DCN, or connected directly to
the PC Ethernet port.
There are two management ports, G1 and G2 in front panel of the Switch Fabric card.
G1 is the interface that should be used for the DCN connection, since it has a configurable IP address.
G2 is the interface that should be used for local access to the Equipment since it has a fixed IP address.
The PC to be connected to G2 must be configured with Fixed IP
192.168.200.200/24
. The OLT equipment IP is defined as
192.168.200.101
.
Notes
Failure to configure PC IP(192.168.200.200/24) may lead to equipment malfunction.
The OLT configuration done through WebTi will be flushed once the OLT is added to NMS server;
The OLT configuration done in Webti will not be reflected in NMS and vice versa.
Figure 5-1: Managing OLT locally
OLT
Uplinks
MPLS
DCN
G1
NMS
WEBTI
VoI
P
se
rv
er
In
te
rn
et
se
rv
er
Vi
de
o
se
rv
er
NMS
Client
WEBTI
Client
Figure 5-2: Managing OLT by the Management Network