Televes OLT 769401, User Manual

Page: 110 / 482

Descripción del producto
110
The Analog RF Interfaces configuration table is composed by the following parameters:
Parameter Description
Port
Port identifier
Admin Port Administrative State
Filter
Selects the filter (All, 15, 25, 35 Channels) to be applied to the RF Interface. In case the user tries to
configure a filter that isn’t supported in the Hardware, the ONT won’t do anything.
Table 5-56 : Analog RF Interfaces configuration table
In CLI remote equipment VoIP interfaces related commands are described section 7.6.17.6.11 “voip” sub- node and subsections.
Figure 5-75: VoIP interfaces configuration
The VoIP Interfaces configuration table is composed by the following parameters:
Parameter Description
Port Port identifier
Admin
Port Administrative State
Hold Over Time (sec)
This parameter determines the time during which POTS loop voltage is held up when the
ONT is not ranged on the PON. When the ONT ranges successfully on the PON, it restores
POTS loop voltage immediately and reset the timer.
Gain dB
Rx
: Specifies the receiver gain (-12.0…+6 dBm)
Tx : Specifies the transmitter gain (-12.0…+6 dBm)
Detail
By pressing view, a window will open and it’s possible to configure additional information
related with the FXS interface
Table 5-57: VoIP Interfaces configuration table
Figure 5-76: VoIP interface configuration