Televes OLT 769401, User Manual

Page: 102 / 482

Descripción del producto
102
Parameter Type Parameter Description
General parameters Admin Ethernet protection Group # administrative state
Type Type Ethernet protection configured (current type- 1:1 protection)
Reversibility
Flag. If selected indicates that the system will switch back to the working interface
after a predefined period of time on the protection state following a switch over
Holdoff time
(x100ms)
Time, in multiples of 100ms, after an alarm occurs, on the working state before
switching over to the protection state.
Wait to restore time
(Min)
Time, in minutes, on the protection state after a switch over, before switching back
to the working state, in the case Reversibility is configured.
Ports
W: ETH Group Working Ethernet Uplink port
P: ETH
Group Protection Ethernet port
Priority:
Switch over conditions’
priority level
classification
Condition
Type of conditions selectable for switch over cause; currently two high priority
conditions can be configured to cause switch over to a protection state
• Generalized Line Card Failure
• LOS
Enable Flag; if selected enables the condition it refers to be used as switch over cause.
Table 5-49: Ethernet protection Group # details Dialog Box parameters
The “Add” button allows the configuration of a new Ethernet protection group, by opening a configuration Dialog Box, Figure 5-. Refer to Table
5- for the description of the configuration parameters
Figure 5-64: Add Ethernet protection Group# Dialog box configuration parameters