Televes OLT 769401, User Manual

Page: 72 / 482

Descripción del producto
72
For each interface, an IP address can be configured and the respective network mask. For InBand, a VLAN must be used since the management
traffic is mixed with other flows.
Parameter Description
Interface Interface name
Active Administrative state of the interface
Address IP address of the interface
Mask
Network mask of the Interface
Management VLAN VLAN identifier used in the inBand interface
Table 5-9: Interface Configuration parameters table
It is also possible to select among all uplink interfaces which ones are used for the in band management. By selecting multiple interfaces, it means
they will be connected in an E-LAN topology for that management VLAN.
Parameter Description
Slot Slot number of the uplink interface
Interface Interface
Inband
If the interface is used or not to manage the system
Table 5-10: Uplink interface for InBand management configuration parameters table
Finally, a gateway may be configured on the system and it must belong to one of the networks configured previously through the IP + Netmask.
Parameter Description
Address Destination IP Network
Mask Destination IP Mask
Gateway/Device Gateway to the configured network
Table 5-11: IP Route - Gateway Configuration parameters table
5.2.4.4 Synchronism
The synchronization block is physically located in the array units. It complies with G.781 and G.810 recommendations and is a category G.813 type
I device.
Internal oscillator ±1.5 ppm;
Holdover deviation ±0.37 ppm per day;
Possible simultaneous sources: 1 Slot; 2 external junctions;
External sources: STM-N Ports, GbE and 10GbE NNI Ports, OTU Ports, 2Mbps Ports, 34Mbps Ports, 2MHz / 2Mbps input/output
junctions;
Priority and Quality (SSM).
The Synchronism configuration sub-menu has two items, Figure 5-25:
Global
PTP