Televes OLT 769401, User Manual

Page: 367 / 482

EN
367
Mandatory Parameters
No
Screen Output
Full command(s) path and used arguments and values to reach the current
configuration.
Table 7-368: “showconfig” command information
/cli/remote-eq/onu> showconfig ?
Usage SHOWCONFIG:
SHOWCONFIG Print the command list that enforces the current configuration
[OPTIONAL]
--onuID Identifies an ONU by ID, in this context.
--port Identifies an interface on the OLT. (e.g.: pon.2; eth.3; lag.1)
Figure 7-406: CLI on line help on “showconfig” command usage in this node context
7.6.17.6.3 “analog-rf” sub-node
7.6.17.6.3.1 “config” command
Name
config
Description
Configures analog-RF parameters for the specified ONU
Full path /remote-eq/onu/analog-rf/config
Mandatory Parameters No
Screen Output No
Table 7-369: “config” command information
/cli/remote-eq/onu/analog-rf> config ?
Usage:
CONFIG Configure Analog RF parameters for a single ONU
[OPTIONAL]
--admin Administrative State. Enable/disable, in this context. (enable|disable)
--filter Choose how many channels to filter. (all|15|25|35)
--onuID Identifies an ONU by ID, in this context.
--port Identifies an interface on the OLT. (e.g.: pon.2; eth.3; lag.1)
Figure 7-407: CLI on line help on “config” command usage in this node context
7.6.17.6.3.2 “show” command
The show command used without parameters shows analog-RF information for the ONU specified with the command
/cli> /remote-eq/connect –onuID=xx –port=ccc.zz.
If there is no connected ONU, all the parameters must be specified to address the desired ONU otherwise the command will return an error
message.