Televes OLT 769401, User Manual

Page: 184 / 482

Descripción del producto
184
7.4.3 About the “showconfig” Command
The showconfig command exists on every node that makes configurations (nodes that have create, remove, config commands).
Since the showconfig command always performs the same action, it will be referred only once to avoid replicating the same information for every
node. The showconfig command help text can be seen in Figure 7-16.
/cli> services/showconfig ?
Usage:
SHOWCONFIG Print the command list that enforces the current configuration
Figure 7-16: CLI on line help on “showconfig” usage in this node context
Syntax /path to node/showconfig
Description
Print the commands needed to reach the current configuration.
Screen Output
Full command(s) path and used arguments and values to reach the current
configuration, e.g., Figure 7-; showconfig command used in the context of time-
zone sub node for a particular system shows the command line that should be
used to configure in the system the current configuration.
Table 7-4: Common Usage Commands
/cli/applications/time/time-zone/showconfig>
/applications/time/time-zone/config
--central-manager-time-zone=”Europe/Lisbon”
--local-time-zone=”Atlantic/Azores”
Figure 7-17: showconfig command screen output example
7.4.4 Invalid Characters
The following special characters are not supported by CLI:
’#£”§»«|
7.4.5 Error Codes
When executing a command, if no information is shown then the command runs successfully. An invalid operation will result in an error code
information message displayed in the screen.
In an error case, any configurations made are cancelled and the user can be sure that nothing has been configured.
There are two types of errors:
Syntax errors , Figure 7-18,
Operational errors, Figure 7-19.
7.4.5.1 Syntax Errors
Syntax errors are shown to the user in red color and are easy to fix, Figure 7-18
These errors occur when the command is not correctly written:
Names are wrong;
Arguments have values out of bounds;
There are missing arguments.