Televes OLT 769401, User Manual, Page: 49 / 482

EN
49
4.5 SFP/SFP+ Insertion and Removal
The SFP/SFP+ module are equipped with a module handle in the front of the module to facilitate the insertion and removal of the
module in the card module interfaces.
Important!
When performing OLT system service actions, observe electrostatic discharge (ESD) precautions, ESD
All SFP/SFP+ modules are hot swappable.
Handle
Figure 4-3: SFP/SFP+ module handle
4.5.1 SFP/SFP+ Module Insertion Handling Procedures
Step 1 Identify the card and the module interface where the module must be inserted;
Step 2
Remove the SFP/SFP+ module interface cover;
Step 3 Remove the module dust cap, to be able to access and turn the module handle to the horizontal position , (please see
Figure 4-);
Step 4
Hold the module by the module handle;
Step 5 Position the module into the card module interface and push it into place;
Step 6
Release the module handle;
Step 7 Cover the module with the module dust cap or plug in the adequate parch cord optical connector.
4.5.2 SFP/SFP+ Module Removal Handling Procedures
Step 1
Identify the card and the module to remove;
Step 2 Remove the module dust cap, or disconnect the optical patch cord, to be able to access and turn the module handle to
the horizontal position;
Step 3
Hold the module by the module handle;
Step 4
Pull the module out of the card module interface;
Step 5
Release the module handle;