Televes OLT 769401, User Manual

Page: 106 / 482

Descripción del producto
106
Parameter Description
Admin
ONU/T Administrative State
Local Module Indicates the local module, Slot/Card pair the ONU/T is connected to
PON Port Indicates the PON Port the ONU/T is connected to
ONU Id
Indicates the ONU/T Identifier
Serial Number Identifies the Serial Number of the ONU/T (16 hexadecimal characters)
Password
Identifies the ONU/T password hex/ascii
Profile
Identifies the ONU/T profile
SW Version
Selects the ONU/T software version mode. In case it’s “Auto”, the version that must be installed in
the ONU/T, is the version defined as Auto in the Firmware Management table for the ONU/T Profile
and HW version. In case it’s a planned version, the version to install to the ONT will be the one
defined. If it’s Off, it won’t be preformed any automatic update.
FEC (Upstream) Flag; if selected indicates FEC is used in the upstream direction
Table 5-52: Inserting Equipment window parameters
There are two different ways to insert a new ONU/T:
•
Online , Figure 5-68: In this case the ONU/T is connected to the GPON Interface and is in “New Equipment” state. To insert the
ONU/T the user must select the ONU/T checkbox and press the “Insert” button. In case the ONU id is “0”, the system will assign
the first ONU ID available in the GPON Interface, in the example, the value in the IDs Column ONU box will change from 0 to 1,
assuming this is the first ONU to be inserted in this PON interface.
•
Offline , Figure 5-69.By pressing the button Create, a window will open. In this window it’s possible to configure the necessary
parameters to insert a new ONU/T (Board, PON Port, ONU id, Serial number and profile), after configuration the button “Add
“must be pressed to insert the ONU/T.
Figure 5-68: ONU/T online insertion