Maintenance Objects
555-233-119
806
Issue 5 October 2002
Table 111. TEST #618 BRI Port Local LAN Loop Around
Error
Code
Test
Result
Description/ Recommendation
1015
ABORT
The port is not in the out-of-service service state.
1. Display the BRI Port Status form with status bri-port PCSSpp to
determine which stations or adjuncts are on this port.
2. Use the extension shown on this form with status station to determine
if the station or adjunct is in use.
3. If it is in use, wait until it is idle. Then use busyout port PCSSpp to
busyout the port, to place it in the out-of-service state, and repeat this
test.
!
WARNING:
Since the “busyout” command is destructive, execution of this
command prior to the port being idle causes all calls associated with
BRI endpoints and all transactions associated with ASAI or adjuncts
on the port to be torn down. Note that third party calls established by
an ASAI or adjunct remain connected even though the port is taken
out-of-service.
1139
ABORT
The Packet Bus in the port network is out-of-service.
1. Follow the repair procedures for the Packet Bus.
2. After completing Step 1, use test port long PCSSpp and review the
results of the BRI Port Local LAN Loop Around Test to verify the repair.
1141
ABORT
The PKT-CTRL is out-of-service.
1. Follow the repair procedures for the PKT-CTRL.
2. After completing Step 1, execute the test port long PCSSpp
command, and review the results of the BRI Port Local LAN Loop
Around Test to verify the repair.
1144
ABORT
The PPN Packet Bus is out-of-service.
1. Follow the repair procedures for the Packet Bus.
2. After completing Step 1, execute the test port long PCSSpp
command, and review the results of the BRI Port Local LAN Loop
Around Test to verify the repair.
2012
ABORT
Internal system error
2100
ABORT
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page