Maintenance Objects
1392
Issue 5 October 2002
2000
ABORT
Response to the test was not received in the allowable time period.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2100
ABORT
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2500
ABORT
Internal system error.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2801
ABORT
The TN802B/TN2302 Media Processor board has not been
administered on the ip-interfaces form.
ANY
FAIL
The test did not detect the test tone through the looparound
connection.
1. Test the tone-clock in the port network that contains the media
processor under test.
2. If the tone-clock is healthy, test the media processor board again.
3. If the test continues to fail, replace the media processor board.
PASS
The board is functioning properly.
0
NO
BOARD
No board was detected by the test.
1. Resolve either wrong board (Error 125) or no board (Error 131)
issues, if applicable.
2. Check that the board is properly translated and inserted. If so,
check for hyperactivity (Error 1538). If hyperactive, use the reset
board UUCSS command.
3. Run the test again. If it fails, the NCE chip on board may be bad.
Replace the board and retest.
Table 361.
TDM NIC Looparound Test (#1380) —
Continued
Error
Code
Test
Result
Description/ Recommendation
Continued on next page