Maintenance Objects
555-233-119
776
Issue 5 October 2002
ATM Board Error Query Test (#1259)
This nondestructive ATM Error Query Test retrieves the most severe, active, on-
and off-board problem from the ATM-TRK circuit pack’s firmware and increments
error counts in the Error Log.
The test passes if there are no errors and fails otherwise. A passing test clears the
software counters; a failure increments the counter associated with the problem
that caused the failure and clears the others.
2100
ABORT
Could not allocate required system resources
Retry the command up to 5 times at 1-minute intervals.
2500
ABORT
Internal system error
Try to reset the circuit pack (reset board UUCSS).
1
FAIL
The circuit pack failed to reset
2
FAIL
The circuit pack failed to restart.
Retry command.
If the problem persists, replace the ATM-TRK circuit pack.
PASS
The ATM-TRK circuit pack is successfully reset.
0
NO
BOARD
No board detected.
Check the error log for Error 125 (wrong board) or Error 131 (no board), and
perform the appropriate repair, if needed.
Ensure that the board is properly translated and inserted.
Check for Error 1538 (hyperactivity). If hyperactive, run reset board UUCSS.
Run the test again. If it fails, replace the ATM-TRK circuit pack, and retest.
Table 99.
ATM Board Reset (#1256) —
Continued
Error
Code
Test
Result
Description/Recommendation
Continued on next page