Maintenance Objects
555-233-119
618
Issue 5 October 2002
Voice and Control Channel Local Loop Test (#13)
This test checks the information and control channels between the Switch
Processing Element (SPE) and the EMBEDDED AUDIX port circuit. First, the
primary information (voice) channel loop back test is run.
While the primary information channel is still looped around, the Control Channel
Loop Around Test is performed. Then the Loop Around Test for the secondary
information (data) channel is performed. This test is the same as the primary
information channel loop around test.
Next, a Conference Test is implemented for the primary information channel. This
test is the same as Conference Test #6.
Only one value (Pass, Fail, or Abort) appears as a result of the four tests run. If
any test fails or aborts, the sequence is stopped.
PASS
The port is using its allocated time slots correctly.
1. To be sure that this is not an intermittent problem, repeat this test up to a
maximum of 10 times to make sure it continues to pass.
2. If complaints still exist, examine the connections.
Table 31. TEST #13 Voice and Control Channel Local Loop Test
Error
Code
Test
Result
Description/Recommendation
ABORT
Internal system error.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1000
ABORT
System resources required to run this test are not available. The port may be
in use. Use display port PCSSpp to determine the voice port extension of
the port. Use status station to determine the service state of the port. If the
service state indicates that the port is in use, wait until the port is idle before
retesting.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page
Table 30. TEST #9 NPE Crosstalk Test —
Continued
Error
Code
Test
Result
Description/Recommendation
Continued on next page